How many amps does a 50 lb thrust trolling motor pull?

Thrust Trolling Motor has a max amp draw of 52 amps/hr but only 5 lbs more thrust. 3. Because of the larger windings in the 50 lb thrust model, lower speeds use less amperage for the same thrust.

What size battery do I need for a 50 lb thrust trolling motor?

Most trolling motor batteries fail due to lack of proper charging. We suggest selecting a 12 volt deep cycle marine battery with at least a 110 amp hour rating, usually a group 27 size battery.

How much amperage does a trolling motor draw?

The Force trolling motor can run on 24 volts or 36 volts, and the chart below shows how a 24v setting will draw higher amps then running at 36 volts.

24 Volt Power Source.

THIS IS INTERESTING:  How many horsepower is a 6 2 liter engine?
Throttle Level Thrust Current
10% 25 N-m (6 lbf) 2 A
20% 45 N-m (10 lbf) 3 A
30% 70 N-m (16 lbf) 6 A
40% 101 N-m (23 lbf) 9 A

How many amps does a Minn Kota Endura 50 draw?

the Endura 45 and 50 also are 42 Max Amp Draw.

How long will a deep cycle battery run a trolling motor?

Amperage Hour Rating

In more technical terms, a 100 amp hour rated battery can deliver 100 amp hours of current to a trolling motor. So if a motor was running at low speed and pulling 4 amps, the battery should last around 25 hours.

How many amps does a 55lb trolling motor use?

The Minn Kota Endura C2 55 Transom – mount 12V 55 lb. Thrust Trolling Motor has a max amp draw of 52 amps/hr but only 5 lbs more thrust.

What size battery should I use for a 55 lb thrust trolling motor?

Using a Newport Vessels 55lb thrust motor continuously for two hours at full speed would require a battery with a 100-120 AH rating.

How long will a 50 amp hour battery last?

This means that a battery has a 100 A.H. capacity if it is discharged over 20 hours, or at about 5 Amps-per-hour (100 A.H. / 20 hours = 5 Amps DC). However, this same battery would last only one hour if the discharge rate was 50 Amps-per-hour (50 Amps DC x 1 hour = 50 A.H.) because of the high rate of discharge.

Do trolling motors need a circuit breaker?

It is highly recommended that a circuit breaker or fuse be used when installing a trolling motor. … For motors requiring a 60-amp breaker, the Minn Kota MKR-19 60-amp circuit breaker is recommended.

THIS IS INTERESTING:  Best answer: Are motor expenses expense?

How can I speed up my trolling motor?

Table Of Contents

  1. Make Your Trolling Motor Faster.
  2. Change the Battery.
  3. Reduce the Load of the Canoe.
  4. Fix a more Streamlined Propeller.
  5. Put on Lighter Attire.
  6. Replace the Existing Motor.
  7. Conclusion.

How many amps does a Minn Kota ulterra draw?

According to the MinnKota spec sheet, the max draw is 56 amps at 24 volts.

What gauge wire is on a trolling motor?

Many trolling motors can be used with 8 gauge wire, however, the length of wire you need and the amperage of your motor can alter the size of wire you need. For example, if you need a longer length of wire, you’ll likely need a lower gauge and therefore thicker wire.

What size fuse should I use for my trolling motor?

The fuse amp capacity will need to be higher than the maximum amp capacity of the trolling motor. For example, if your trolling motor has a maximum capacity of 38 amps, you’ll need at least a 40- or 50-amp fuse.

What size battery do I need for a 40 lb thrust trolling motor?

VMAX V35-857 12V 35AH AGM Deep Cycle U1 Battery (7.7″x 5″x 6.1″) for 12 Volt 40 Pound 40lb Thrust Trolling Motors.

How fast will a 55 lb trolling motor go?

Assuming perfect riding conditions, the use of the best fuel i.e. the distillate marine diesel, and moderate load, 55-pound trolling motors are likely to attain a maximum speed of only 5 miles per hour. This would take around two hours for the deep cycle battery charge to get completely depleted.

THIS IS INTERESTING:  Frequent question: What is the best automatic transmission cooler?

How long will a 12V 100Ah battery last for a trolling motor?

A 12 volt 100Ah lead acid deep-cycle battery will power a 30lbs thrust Minn Kota trolling motor on Speed 4 setting for about 4 hours.