What three safety precautions must be observed when working around engines?

What are the 3 safety precautions?

General Precautions

  • Your safety is your personal responsibility.
  • Always follow the correct procedures.
  • Never take shortcuts.
  • Take responsibility and clean up if you made a mess.
  • Clean and organize your workspace.
  • Ensure a clear and easy route to emergency exits and equipment.
  • Be alert and awake on the job.

What are the precautions observed before engine starting?

Don’t press the gas while starting the engine. Always make sure the car is in park before starting the engine. Don’t hold the key in the start position for more than 30 seconds. If the engine isn’t running, avoid leaving the key in the on or accessory position as it can drain your battery.

THIS IS INTERESTING:  Frequent question: Is it bad if a car doesn't have a full service history?

Which precautions should you take when working on engine and exhaust hot components?

Wear gloves when handling hot engine components. Do not remove radiator cap unless engine is cold. Pressurized engine coolant may be hot. Do not touch hot exhaust systems, manifolds, engines, radiators, sample probe, or other hot parts.

What are the safety precautions to be made during the maintenance of a vehicle?

Here are 10 engine maintenance tips that’ll help your engine run forever:

  • #1. Change engine oil at regular intervals. …
  • #2. Keep check on the cooling system. …
  • #3. Let it breathe. …
  • #4. Look for leaks. …
  • #5. Don’t keep going on reserve fuel. …
  • #6. Check your belts. …
  • #7. Don’t ignore the check engine light. …
  • #8. Replace your fuel filter.

What are the safety precautions in the workplace?

8 Safety Tips in the Workplace

  • Always Report Unsafe Conditions. …
  • Keep a clean workstation. …
  • Wear protective equipment. …
  • Take breaks. …
  • Don’t skip steps. …
  • Stay up to date with new procedures or protocols. …
  • Maintain proper posture. …
  • Offer guidance to new employees.

What are the safety precaution?

safety precaution in British English

(ˈseɪftɪ prɪˈkɔːʃən) a precaution that is taken in order to ensure that something is safe and not dangerous. safety precautions visible everywhere: lifejackets, small boat, inflatable rubber boats.

What are the main engine safeties?

Main Engine Safety devices

Main Engine Safety Devices Main Engine Alarms and Trips
1. Crankcase Relief Door 1. Over Speed Trip
2. Scavenge Space Relief Door 2. Lube Oil Low Pressure Trips
3. Cylinder Head Relief Valve 3. Camshaft Lube Oil Low Pressure Trip
4. Starting Air Relief Valve 4. JCW low pressure trip
THIS IS INTERESTING:  What do you do if your car battery is leaking acid?

What safety precautions must be observed when working around a manual transmission?

Safety glasses/goggles only protect your eyes. Gloves protect your hands and should be long enough to cover your overall sleeves. This prevents the hot manual transmission fluid from trickling down your arm.

What precautions are needed when draining the engine oil from an engine?

Remember that the oil may be very hot, so avoid contact with it. Wait until no more oil drips from the drain hole, then clean the drain-hole threads and the surrounding area with a clean cloth or tissue. Clean the drain plug too, and make sure its washer or gasket is in good condition.

What five 5 precautions should be observed if a vehicle is to be raised on a hoist?

Here’s what they advised.

  • Read the owner’s manual before you begin. …
  • Check the specific “lifting points” of the vehicle you’re working on. …
  • Never exceed your vehicle lift’s maximum capacity. …
  • Don’t rely on a single lift arm to bear all the vehicle’s weight. …
  • Choose an auto lift with automatic safety locks.

What safety considerations should be considered when working with motors?

Safety Rules

  • You should always keep your work area clean and well lit.
  • All motors include many small parts; keep very young children away from your work area.
  • Motors spin very fast; always wear safety goggles.
  • Super Glue, provided with most of the kits, is “instant bonding”.

What precautions should you follow if you are performing electrical work on a vehicle?

Always disconnect the battery when working on electrical systems and near/around electrical wiring. Even when the vehicle is off, there is still the potential for current to pass through electrical wiring. Never place hands, tools, or other objects near the engine while it is running.

THIS IS INTERESTING:  How do electric vehicles affect methods of electricity generation?

What are three 3 reasons for asking question when carrying out diagnosis?

Here are a few reasons why you might want to ask questions:

  • You discover something new. Often, when you ask questions, whether they’re related to something within the company or not, you discover something new. …
  • You put things together. …
  • You remember things. …
  • You resolve issues. …
  • You understand people better.

What are the safety measures and precautions for doing repairs?

If you do gear up to make simple repairs, here are some safety tips to keep you and your home safe.

  • Research. Always know what you are up against. …
  • Proper Safety Equipment. It’s amazing how many people don’t use basic safety equipment. …
  • Proper Tools. …
  • Clear Workspace. …
  • Don’t Push It. …
  • Bonus Tip: Call a Professional.

Why do we have to observe safety measures and precautions when doing repairs?

Safety precautions must be strictly adhered to because if they are not, some employees can put all other employees at risk. Work place accidents translate into days missed for work, reduced productivity, and lost profits. … Employees should feel safe at work and protected from hazardous materials and dangerous machines.