Frequent question: Can a car throw codes without check engine light?

In short, yes; it’s possible to diagnose a problem with a vehicle even if the check engine light does not illuminate. A professional mechanic would start by downloading any error codes store in your 2005 Ford Explorer’s computer.

Can AutoZone read codes without check engine light?

You can. All that you need to check your own light is an OBD-II reader, which can pull codes that help you find out what’s wrong with your car. If you don’t have a code reader, keep reading to learn the most common causes, and then bring your car to your local AutoZone to find out why your Check Engine Light is on.

Why would check engine light not come on?

If the dashboard light is good, then the ECM could be defective causing the light to not come on. Try removing a sensor harness and see if the light comes on. … If it does not, then check the computer for codes for the sensor you unplugged. If there is a code, and the MIL indicator says ON, then the light is burned out.

THIS IS INTERESTING:  Can I trade in a car that needs a new transmission?

Can AutoZone clear engine codes?

Did you know that you can get your check engine light scanned for free? Any of the major parts stores in the country, such as: Napa, Advance Auto, Autozone and O’Reilly’s, will scan your vehicle, and tell you the P codes for no charge at all.

Where can I read car codes for free?

Many drivers don’t realize that AutoZone, the nation’s largest auto parts chain, will do the following services free of charge: Read the codes on your check engine light.

Can you drive with check engine light on?

The rule of thumb is that if the check engine light is flashing, you can’t keep driving the car. It’s an emergency. Often it indicates an engine misfire. If you keep driving, you will likely cause irreversible damage, mostly to the (expensive) catalytic converter.

How long can you drive with check engine light on?

When the check engine light is solid, you can typically drive the car for hundreds of miles without an issue. Of course, that depends on which code is stored in the vehicle’s computer. If an engine sensor is faulty, the car will usually use made up sensor values to keep running.

What is the most common reason for check engine light?

Replacing a faulty oxygen sensor — a sensor used to optimize a vehicle’s fuel-to-air mixture to increase gas mileage and reduce emissions — is the most common cause for a check engine light.

Will disconnecting battery clear codes?

Leaving the battery disconnected for about 15 minutes will ensure the vehicle systems will completely reset when you reconnect the battery. … Disconnecting the battery will clear the error codes and reset the check engine light.

THIS IS INTERESTING:  Frequent question: Do you need an extra car seat?

How long do I have to drive my car to reset the computer?

So why is the light still on? Here’s something you probably don’t know: after clearing the car’s computer you will need to drive for about 50 to 100 miles. As you drive your car the computer will monitor all the sensors and register the results.

How much does it cost to check engine light?

On average, the fee to have an auto mechanic diagnose a check engine light is $100.

Do code readers work on all cars?

Most OBD2 scanners and car code readers do not work on all cars. If you are looking for an OBD2 scanner or car code reader, you should check if it works with your particular make and model before buying it.

Where do you find engine codes?

The first step is to read the check engine light code provided by the car’s computer system. This is the information that’s been logged by the sensors in your engine. It can be read with OBD II scanners or readers through a connection (OBD port) usually located under the steering column.