Can AutoZone turn my check engine light off?

Wondering if the local Autozone can turn off a check engine light? The answer is yes, but… there are a couple things to remember: Local auto parts stores will typically offer to read your codes for free, but not all locations will clear the light due to liability issues.

Can AutoZone reset a check engine light?

Did you know that you can get your check engine light scanned for free? Any of the major parts stores in the country, such as: Napa, Advance Auto, Autozone and O’Reilly’s, will scan your vehicle, and tell you the P codes for no charge at all.

How much does it cost to turn off check engine light?

According to the 2017 Vehicle Health Index compiled by the automotive diagnostic website CarMD in Irvine, CA, the average cost to resolve an indicated check engine light issue is $398 including parts and labor, which is 2.7% higher this year than it was in 2016.

Can a dealership turn off a check engine light?

It is illegal for a dealer to DISABLE the check engine light. But to re-set it after a service or a scan is not illegal.

THIS IS INTERESTING:  How do I know if my engine needs to be replaced?

Will AutoZone read check engine codes?

Many drivers don’t realize that AutoZone, the nation’s largest auto parts chain, will do the following services free of charge: Read the codes on your check engine light. Test your battery’s voltage. Check your alternator and starter.

Is it OK to drive with check engine light on?

The rule of thumb is that if the check engine light is flashing, you can’t keep driving the car. It’s an emergency. Often it indicates an engine misfire. If you keep driving, you will likely cause irreversible damage, mostly to the (expensive) catalytic converter.

Can you ignore check engine light?

The light is an indicator that there’s something wrong with your vehicle. … “The system is telling you that something has failed and will immediately cause damage to your vehicle that will be costly to repair.” Ignoring your check engine light could result in immediate car problems or deterioration over time.

How far do you have to drive to reset the check engine light?

To make sure the check engine light does not reappear, it’s recommended that you drive your car 30 to 100 miles. This enables the vehicle’s “Drive Cycle” to reset, as the various sensors need time to recalibrate.

Where can I take my car when the check engine light is on?

Bring your car to an auto parts store and have the code read for free. The free check engine light diagnosis is good because if the code turns out to be for something minor, you might even be able to fix it yourself. 3. Buy an inexpensive scanner and read the code yourself.

THIS IS INTERESTING:  How much does cold weather affect electric cars?

What code reader does AutoZone use?

AutoZone | Innova’s 3040 OBD II Code Reader.

Can AutoZone tell you what’s wrong?

If your check engine light is on and you need to figure out what’s wrong, come to your local AutoZone and ask about Fix Finder. … AutoZone gives you a FREE, easy-to-read MYZONE HEALTH REPORT, which includes relevant codes, and details the action that needs to be taken.

What is the most common reason for check engine light?

Replacing a faulty oxygen sensor — a sensor used to optimize a vehicle’s fuel-to-air mixture to increase gas mileage and reduce emissions — is the most common cause for a check engine light.